Remco Drive Shaft Disconnect .250 Coupler Shift Rod. Comes in a 5" or 6" length. You can simply cut the rod with a hack saw to obtain a custom length.
MFG# 5"-11000565 6"-11000563
Remco Driveshaft Disconnect Shift Rod Clevis.
Remco Driveshaft Disconnect Clevis Clip. Used for both Driver or Passenger side linkage.
Throttle clips are used to connect the shift rod to the Shift Fork (Horse Bit). They're available for left and right side shift linkage configurations. If your engage linkage is on the drivers side select "Right Clip". If your engage linkage is on the passenger side select "Left Clip". Older model Horse Bits (uses cotter key) will need to have the top of the Horse Bit arm
slightly ground down
in order for the throttle clip to rotate over the top.
Remco Cable Support Bracket. Used for both left and right side engagement linkage.
Remco Control Rod Lever. Used for both left and right side engagement linkage
Shifter Housing. If you are reworking your existing Disconnect Driveshaft to use in a
different vehicle or you have damaged your original housing beyond repair, you can order a new Housing here. Comes with
complete vehicle specific housing, cable, installation components and instructions/manual. There are at times because
of differential configurations, we will require a few pictures of the differential center section in
order to supply you with the correct housing. We will contact you if this is the case.
(does not include the driveshaft or disconnect unit)
Complete Shifter Housing w/cable, attachment hardware, instructions/manual $236.00